ModelEngineCastings.Com
  • Home / Barstock Engines
  • Engine Casting Kits
  • Cool Links
  • Contact
=================================================================
The Silver Bullet
Picture
Bob Shores Engine
Picture

                                          Bob Shores Silver Bullet Casting Kit, Plans, and Builder Hints


Description:

4 Cycle 2 cylinder gas engine                             Adjustable ignition timing    
3/4 inch Bore and Stroke                                     Antifreeze capacity 40cc
Displacement : .66 Cu In.                                     Oil capacity 20cc
Horsepower  @ 3,600rpm  .095                            Fuel capacity 2oz.
Side operated Valves                                           Cast Iron Sleeve and rings                            
Aluminum piston                                                   Gear type water pump
Self compensating carburetor                            Authentic Efficient Radiator Plans included
 
Minimum lathe swing required - 6 inch

 (28) 11x17 high quality drawings
  23   pages of suggestions for the novice

 Casting set consisting of:
     Cylinder block
     Oil Pan
     Bell housing
     Gear cover
 
High strength aluminum alloy castings from original patterns from Bob and Margaret Shores.
 
================================================================
The Little Hercules
Picture
Bob Shores Engine
Picture
                                        
                                     Bob Shores Hercules Casting Kit, Plans, and Builders Hints

Description: This is a smaller version of the Silver Bullet
4 Cycle 2 cylinder gas engine                           Adjustable ignition timing    
.625 inch bore and stroke                                  Antifreeze capacity 40cc
Oil capacity 20cc                                                 Geared type water pump
Fuel capacity 2oz.                                               Authentic Efficient Radiator plans Included                                    
Side operated Valves                                           
Cast iron sleeve and rings                                   
Aluminum piston                                                   
Self compensating carburetor
 
Height oil drain to rockers 4.60 inches
Width 2.5 inches
Length 6 inches
 
Minimum lathe swing required to build 6 inch
 
(28)  11x17 high quality drawings
33 Pages of suggestions for the novice
 
Casting set consisting of:
        Cylinder block
        Oil Pan
        Bell housing
        Gear cover
 
High strength aluminum alloy castings from original patterns from Bob and Margaret Shores

   ===============================================================
The Silver Eagle
Picture
Picture
Bob Shores Eagle Hit or Miss Model Engine Castings Drawings and Builders Hints
Description: 
1 Cylinder, 4 cycle, Hit and Miss, 7/8 bore X 7/8 stroke
 Bore  =  .875", Stroke = .750"
Height = 4.250", Width = 5.125", Length = 8.250"
Flywheel Diameter =3.625 , Flywheel width = 1".
Spark plug = 1/4-32, Plug gap = .015"Cylinder liner = Cast Iron
Piston - Cast Iron / 1 Ring
Water cooled.
Fuel = 1 part WD-40, 9 parts Unleaded Gasoline
Idle speed = 300 RPM typical
Governor = centrifugal fly ball, adjustable

 (12)    11x17 high quality drawings
 (15)    Pages of suggestions for the novice
 
Casting set consisting of
         Frame casting
        Crank cap castings
        Cylinder head casting
      2 Bronze flywheel castings


Aluminum high strength Alloy from restored original Patterns from Bob and Margaret Shores
 Note these are all from the original drawings and Patterns Bob Shores, All rights reserved.

Site powered by Weebly. Managed by Lunarpages